Dedicated riveting for 174-line and RG58 coaxial center pins
The LP-CR174 rivets the center pin of 174-line and RG58 coaxial cables with controlled force and a repeatable stroke, delivering a stable mechanical joint for RF and antenna interconnects where soldering is not preferred. Riveting recipes and process data are digitized for full traceability.
Typical applications: Telecom & 5G / RF · Radar & Communications · Aerospace & Defense
Talk to an Engineer →| Applicable cable | 174-line / RG58 coaxial |
|---|---|
| Process | center-pin riveting |
| Force control | closed-loop |
| Throughput | 500–800 pcs/h |
| Data | MES-ready export |
| Change-over | quick, per cable type |
High-accuracy servo crimping for micro-rectangular twist-pin connectors
100% in-line wire-sequence verification with automatic marking
15-station one-operator antenna assembly cell
Share your sample or drawing, target throughput and quality standard — we reply within one business day.
Request a Quote →Connector and wire-harness production lives or dies on repeatability. Manual crimping and bench assembly introduce operator-to-operator variation, scattered process steps and rework that only surface at final test. The 174 / RG58 Center-Pin Riveting Machine concentrates crimping equipment into a controlled, data-logging station so quality is built in, not inspected in.
It is most often specified for Telecom & 5G / RF, Radar & Communications, Aerospace & Defense, where unstable accuracy, high scrap and slow delivery are the recurring pain points. Because recipes and process data are digitized, the same machine scales from low-volume, high-mix programs to high-volume production without re-engineering the cell.